xTool F1 Ultra Laser Engraving Embossing Silver Plates

[Javier Odom]

I’ve used my F1 Ultra to engrave 0.5 mm deep (and probably deeper) in sterling and fine silver. Rather than the Engrave process which limits the number of passes to ten I will use a .png with my design in black on a transparent background and go with Emboss—my go-to settings for silver and brass are Fiber IR, 120 layers, 95% power, 300mm/sec speed, 1 pass, 300 lines/cm, 7° engraving angle, 30kHz, z-axis descent 0.01mm each layer. - PopeCovidXIX: A question on engraving.