xTool F1 Ultra Laser Engraving Brass Plate for Hand Engraving Template
Posted: Tue May 13, 2025 1:44 pm
This is for the xTool F1 Ultra.
The following settings are for a 1.3mm brass plate, using an SVG image file. Once this has been laser engraved the engraved/etched template can be used to hand engrave the plate.
The following settings are for a 1.3mm brass plate, using an SVG image file. Once this has been laser engraved the engraved/etched template can be used to hand engrave the plate.
- Fiber IR
- Power: 55%
- Speed 3,750 mm/s
- 1 Pass
- 300 lines/cm
- Bi-Directional
- 30 kHz