Using the Jewel3D v2.0 software, calibration is fairly simple.
- Open the Jewel3D software
- From the top right menu options, click the Calibrate button.
- Select the calibration mount plate that you have. I have the CB-5mm. The other option is the CB-10mm.
- Click the Confirm button.
- Place the calibration mount plate on the machine.
- Lower the vertical and horizontal settings to their lowest setting, in the bottom left of the screen.
- Click the Calibrate button.
- Click the Confirm button to exit the calibration.
When the calibration is completed a notification will appear at the top center of the screen. It will be similar to the following:
Result accuracy as 0.0031mm Extreme Value 106
Some additional considerations.
- Be sure your calibration mount plate is clean.
- When you remove the mount plates, do not shift the rotating arm.
